Daily Cleaning of Housing and Connections
Wipe away water promptly: After each use, wipe any residual water off the filter housing with a soft cotton cloth to prevent limescale buildup from corroding the plated finish.
Gentle grease removal: Clean the housing with warm water and a small amount of neutral dish soap, then rinse and dry; do not use steel wool or strong acidic/alkaline cleaners, as these can scratch or corrode the housing.
Check connection seals: Inspect the connection between the filter and the faucet every 1–2 months. Tighten the mounting screws immediately if seepage occurs, and replace worn-out sealing rings to prevent leaks from damaging the cabinet.
Regular Cleaning and Maintenance of Filter Cartridges
PP Cotton/Stainless Steel Mesh: Shut off the water inlet valve and remove the cartridge. Rinse it under running water for 30 seconds, alternating directions along the texture/mesh pattern. Use a soft-bristled brush to gently remove sediment or rust from crevices, then rinse until no visible stains remain and let it drain before reinstalling.
Activated Carbon Cartridge: Remove the cartridge and soak it in room-temperature water for 10–15 minutes, gently shaking it to release trapped impurities. Then, rinse under running water until the outflow is clear and odorless. Note that cleaning only partially restores adsorption capacity.
Ceramic Cartridge: Gently scrub away surface limescale with a soft-bristled brush; avoid vigorous scrubbing that could damage the internal microporous structure. Rinse clean after scrubbing and it is ready for reuse.
